#PWM to PPM & SBUS converter

With sbus code from https://www.rcgroups.com/forums/showthread.php?2420473-Arduino-S-BUS-Packet-Generator-Code

• an Arduino with a Atmega328 or 328p chip on it.
• IDE to program the chip with this code.

How:?

• Used Arduino IDE to program this firmware onto the Arduino chip.

• Connect upto 8 RC PWM input signals so that the wires go to: red = 5v black = GND or 0V pin on arduino white = PWM signal pins, these connect to D8,D9,D2,D3,D4,D5,D6,D7

• Connect the PPM output so that the wires go to: red = 5v black = GND or 0V PPM out = D10

Done!

TIPS:

• any channel that you don't connect a PWM input on, will emit a default value ( which is 1500 for all channels excpt throttle, which is 1100.
• disconnecting any channel after booting will cause the system to use the last-known-position of the input, until a good signal returns.
• having pin PC3 (Arduino A3) pulled high on startup produces human readable serial 115200,8n1 output of the channel data instead of sbus
• This is not a "failsafe" unit, if has no failsafe functionality.
• If this code causes your expensive toys to crash, or worse, it's your fault for being a bad person, so you should be nicer, as karma's a bitch.
• Not my fault. none of it. I love you too, now go away.