pnoll1 / marlin Goto Github PK

after a flash, coded values are over written so that a M502 is required to set values to the ones flashed. it would be good if m502 was automatically done to ensure it's not forgotten

left 40mm of bed can't be auto probed due to probe offset leading to unusable print quality on most of that part of bed. could use UBL and manually probe with nozzle.

current motor setting is very smooth and slow. need to investigate upping motor currents along with features like s curve accel and junction deviation to retain print qualtiy.

display is on but only shows characters in non sensical, repeating order

language support is possible culprit

sd tries to initialize upon startup and fails. also tries to init when a card is inserted

sets cornering velocity/accel based on junction angle. needs tuning by printing something like https://www.youmagine.com/designs/multi-angle-test-tower-for-calibrating-jerk. no official documentation in marlin. smaller number results in slower speeds

G29 slower than MM3 with bltouch older marlin 1.1. upward z movements after probing could be sped up

print fan set to 30% but was noticed off at z5.6.