Davinci 1.0 AiO Black Bars after SD card removal about repetier-firmware-4-davinci HOT 5 CLOSED

It looks like you got a short when removing the SD that damaged the flash could be static electricity also when you touched the board

first thing is to make your printer detected
1 - use jumper to reset the board (J37 for AIO) and do it slowly
if your board is still not detected by window when you plug USB - I am afraid that there is not so much to do but start to change the board by a new one

2 - if you succeed then need to reflash the board following readme process

from repetier-firmware-4-davinci.

I already tried following your instructions from a different thread to jump it for 10 seconds then do it another time to be sure. No luck with that either.

My guess if I'm going to have to change the board. Is there somewhere that I can look into getting a new board? I have no idea where to shop for something like that (preferably a Canadian site if you know one)

from repetier-firmware-4-davinci.

No sorry - ebay is the best chance I guess - Davinci boards are pretty fragile due to the cost down company is doing

My suggestion would be to think about a mod changing the main board for real printer board if you cannot find a replacement board

from repetier-firmware-4-davinci.

No sorry - ebay is the best chance I guess - Davinci boards are pretty fragile due to the cost down company is doing

My suggestion would be to think about a mod changing the main board for real printer board if you cannot find a replacement board

Okay thanks for the info!

Is there a thread on here for doing that or is that something I'd need to find elsewhere?

from repetier-firmware-4-davinci.

I would go here : https://www.soliforum.com/forum/21/xyz-printing-davinci/
and https://www.thingiverse.com/groups/da-vinci and google of course ^_^

from repetier-firmware-4-davinci.