keebio / sinc-case Goto Github PK

From here https://keeb.io/collections/split-keyboard-parts/products/sinc-split-staggered-75-keyboard?variant=32113454383198 I understand there's a left side with no macro and left w/ macro version, but what's the variation on the right side?

The rev1 pcb connectors do not fit the current enclosure design.

Expected Behavior

The pcb should just pop in. The tssr connector is too big for current hole. The USB-C might be problematic too.

Current Behavior

Pcb does not go in fully when assembling. Tried to install normally but I could not get it to fix.

Possible Solution

Enlarge the connector holes. I fixed this in a minute by plunging a soldering iron throw the holes in order to enlarge them. Would not recommend.

Context

Was not ideal for my build. Altough I wish I did not have to enlarge the holes with an soldering iron.

Hi,

I have recently purchased sinc prebuilt from keeb.io which comes with the FR4 plates and have a couple queries

What are all the items i need if want to print the enclosed case? I think:

• Top Shell - Left Macro with Encodes
• Top Shell - Right with Encoder
• Mid Layer - Rev 2 Left Macro
• Mid Layer - Rev 2 Right

Questions:

1. Do i also need 'switch-plate' and 'Bottom-plate' (or are these part of the pre-built)?
2. What is the 5mm plate used for?
3. Also, is it possible to get the enclosed case files in STEP format? The place where i am sending the print requires STEP.

Many thanks!

Hi! I think I have the same "problem" as #2. The PCB and a bit of the trrs plug seem to be pushing the case out.

Some pictures:

I didn't understand the resolution to #2? Is it supposed to be like that? Do I need to desolder my pcb to use this case? Is it just a bad print?