New enclosure rev 1 design problem. about sinc-case HOT 9 CLOSED

Can you take a picture and post it here? I did do a test print of https://github.com/keebio/sinc-case/blob/master/enclosed-case/Mid%20Layer%20-%20Rev%201%20Left%20Macro.stl and https://github.com/keebio/sinc-case/blob/master/enclosed-case/Mid%20Layer%20-%20Rev%201%20Right.stl, and they fit fine with my build.

from sinc-case.

Sorry for the bad pictures. I have my left half fully assembled and I did not want to take it apart for a couple of pictures.
Maybe the tolerances are so tight that my printer could not print it right? But when inserting the pcb for the first time, I did get the pcb in but there was noticable collision between trrs port and the housing.

from sinc-case.

The plate edge should not be flush with the case edge, as it should be 4mm from the edge (top shell will cover the gap). It should look like this in the end:

from sinc-case.

Oh my, I done goofed up. Your build looks great btw!

from sinc-case.

Hi, I am getting a similar issue.

From looking at it, the trrs port is a square where it passes, and the case is a circle. I guess I just have to make an expansion now?

from sinc-case.

As mentioned earlier in previous comment, the middle layer edge is not supposed to be flush with the plate edge. It’s 4mm extra on the sides.

from sinc-case.

I understand this, but the extruding PCB that the trrs & usbc is soldered to blocks the screw holes from aligning

from sinc-case.

Okay, turns out the test fit I had done here (#2 (comment)) was with a prototype version of the PCB that had the ports inset more by about 3.5mm.

I'll be reworking the middle layers and will post up new files.

from sinc-case.

Fixed now with ac02833
These have been printed and tested with the production Rev. 1 PCB.

from sinc-case.