[Request]: When enabled in Firmware, Add M306 data to Temperature tab about octoprint-eeprom-marlin HOT 7 CLOSED

I can add MPC stuff, it was on my radar to try out on my own printer and as a new addition to the firmware had not yet been added. At least it's an easy one to work out the format of...

from octoprint-eeprom-marlin.

I've added support for this to the data model. I am not sure when it will be released, it depends if I start tackling the other issues which could be more work.

Both for PID tuning and for MPC tuning, would be a great feature to show the (link to) the gcode needed to tune those parameters, as these arent values you tune by hand.

There should be a small blue (i) button beside the entries with links to the configuration gcode. For MPC there is one gcode for everything, but for PID it is slightly different with separate commands.

from octoprint-eeprom-marlin.

nope, no i button

I do know where to find the gcode to do a PID, but every time i have to look it up ;)

from octoprint-eeprom-marlin.

Hmm, this is what I have on my end (I realize now it is not an info button but just a link):

Can you confirm which version of the plugin you have installed? It's either in the plugin manager, software update or at the bottom of the plugin's settings page.

from octoprint-eeprom-marlin.

Version 3.2.0
newest according to both octoprint and github

my setup: Ender 3 with SKR Mini e3 V2 on Marlin 2.1.xx bugfix, connected through octoprint.
Have UI customizer, but checked and also doesnt show up with UI customizer enabled

from octoprint-eeprom-marlin.

I have no idea why that is not showing on the tab for you then...

from octoprint-eeprom-marlin.

MPC configuration is now available in 3.3.0rc1, which you can get by switching to 'Release Candidate' in the software update settings.

from octoprint-eeprom-marlin.