This is a replacement Z-Carriage (for Robo 3D R1) that allows for quick removal of X-carriage and X-rods without disassembling the printer.

This is still a work in progress and is not ready to be used.

This is based on parts of Complete RoBo3D Printer by Mike Kelly.

• Add changelog
• Redo clamp design
  • Releasable without removing belt, motor, or idler pulley
    • Maybe not important, since you need need to release the belt to remove the X-carriage anyway
  • Releasable without removing X-endstop
    • Make X-endstop be built in to clamp?
  • Template-ized so it's the same for all four corners, only requiring mirror().
• Build Left (idler) side
• Clean up code for Right (motor) side
• Sizing / Fitting / Calibration test piece generation
• Move original source STLs to subdirectory to avoid confusion
• Photos
• Video
• Add to:
  • Thingiverse
  • MyMiniFactory
  • YouMagine