A hwmon Linux kernel driver for exposing sensors of the Aquacomputer Octo fan controller.
Supports reading temperatures and speed, power, voltage and current of attached fans. The speed of the flowmeter is reported in l/h and is only correct after configuration in aquasuite. Being a standard hwmon
driver, it provides readings via sysfs
, which are easily accessible through lm-sensors
as usual:
bill@debian:~> sensors
octo-hid-3-14
Adapter: HID adapter
VCC: 12.11 V
Fan1 voltage: 12.07 V
Fan2 voltage: 12.11 V
Fan3 voltage: 12.11 V
Fan4 voltage: 12.11 V
Fan5 voltage: 12.11 V
Fan6 voltage: 12.11 V
Fan7 voltage: 12.11 V
Fan8 voltage: 12.11 V
Flow speed [l/h]: 0 RPM
Fan1 speed: 3028 RPM
Fan2 speed: 1167 RPM
Fan3 speed: 1161 RPM
Fan4 speed: 1155 RPM
Fan5 speed: 1154 RPM
Fan6 speed: 1137 RPM
Fan7 speed: 1129 RPM
Fan8 speed: 0 RPM
Temp1: +24.8°C
Temp2: +29.7°C
Temp3: +30.9°C
Temp4: +327.7°C
Fan1 power: 4.88 W
Fan2 power: 260.00 mW
Fan3 power: 260.00 mW
Fan4 power: 300.00 mW
Fan5 power: 290.00 mW
Fan6 power: 300.00 mW
Fan7 power: 300.00 mW
Fan8 power: 0.00 W
Fan1 current: 405.00 mA
Fan2 current: 22.00 mA
Fan3 current: 22.00 mA
Fan4 current: 25.00 mA
Fan1 current: 24.00 mA
Fan2 current: 25.00 mA
Fan3 current: 25.00 mA
Fan4 current: 0.00 A
Go into the directory and simply run
make
and load the module by running (as a root)
insmod aquacomputer-quadro.ko
To remove the module simply run
rmmod aquacomputer-quadro.ko
based on aquacomputer_quadro-hwmon