worker nodes don't join the cluster anymore about hetzner-k3s HOT 3 CLOSED

Can you SSH into the worker and check if it has /etc/systemd/system/k3s.* files? If yes, source the .env one and try starting the service command manually to see if it prints an error that helps understand what's the problem.

from hetzner-k3s.

It is like it always is... the moment I create an issue and retry it works...

Hetzner seemed quite slow the whole day (at least the console). I would guess it was some sort of timeout when the nodes join the cluster.
One autoscaling node needed 5 minutes until it finally joined the cluster.

I just retried it a minute 2m18 ago:

NAME                                          STATUS   ROLES                       AGE     VERSION
test-cax11-master1                          Ready    control-plane,etcd,master   2m18s   v1.28.3+k3s2
test-cax11-pool-cax11-worker1               Ready    <none>                      83s     v1.28.3+k3s2

55 seconds it totally acceptable.

Sorry for the noise. Closing this again and going to sleep.

from hetzner-k3s.

No problem. Two days ago I had problems with Falkenstein, I was creating a cluster and servers were created but booted only after several minutes, which is not usual with Hetzner, and then when I was deleting a cluster it would get stuck at deleting the network. It was quicker to delete the project.

from hetzner-k3s.