welcome to the front page of the LCIF project (Lossless Compressed Image Format), this is a file format developed over 8 months (0001 and 0002) based on linear image compression

LCIF compression is a linear compression algorithm that uses 2 main compression methods, repeated color compression and common color variable compression.
Common Color Variable Compression takes common colors in the image and sorts them into a list at the start as variables callable by 8 bits instead of 24 or 32 bits for RGB and RGBA pixels.
Repeated Color Compression notices when a color is repeated more than one time and writes that color once and attaches a number to represent the amount of times to repeat it.

• 100
  • the original version, completely ram based and uses CCVC variable compressing
• 101
  • improvements were made to speed
• 102
  • introduction of SPVC variable calculation method
  • introduction of RRAW intermediary format
  • uses ramdisk, saves memory
• 103
  • QOL improvements with information displays
• 104
  • instead of going from png to raw to RRAW to LCIF, it now goes directly from png to RRAW, speeding up decoding
• 105
  • introduced faster binary decoder for RRAW data

• 110
  • introduction of LCIF 0002 standard, can decode 0001 and 0002 and encodes 0002
• 111
  • QOL improvements
• 112
  • QOL improvements
• 113
  • disabled limiter on PIL max pixels
• 114
  • moved to faster binlen calculation function, increases compression
• 115
  • introduced faster binary decoder for RRAW data
  • introduced Bit By Bit (B3) decoder that stream decodes 0002, 0001 decoder not changed
• 116
  • greatly increased speed of RRAW encoder
  • added VerConfig with build information
  • added -c, --config flag that prints VerConfig data
  • greatly improved RAM usage of encoder
• 117
  • Multithreading!
    • RRAW 0/1 is now done simultaneously for a slight speed increase on SSDs or underpowered CPUs
    • LCIF encoding is now multithreaded
  • LCIF encoding no longer makes "LCIF" file, it directly writes to finalout as it encodes, uses a new conversion layer "BinaryBytes"
  • RRAW20 has been replaced with RRAW4V
    • New standard allows for a variable RRAW data size, in most cases cutting RRAW filesize in half
    • Noticable speed increase on reading and writing RRAW
  • Program gives warning if using python version 3.7 or below, as it is much slower than 3.8
  • More consistent CLI

• added V117 encoder

• added V116 encoder
• added LCIFstat V100
• added LCIF 0002 statistics decoder, based on B3:1.1.5

• updated 0003 specification file, it is still nowhere near complete but now some groundwork has been laid down

• updated README.md
• found V100 lying in the dustbin, its not much

• added V1.0.5 encoder, uses a faster binary decoder for RRAW data and improved ram usage on encoding
• added V1.1.5 encoder and decoder, uses a much faster encoder and a slower but vastly more ram efficient decoder

• added V1.1.4, uses a better repeat binlen calculation function, also improved encoder ram usage
• minor tweaks to changelog
• added section "The Theory" to explain the idea behind LCIF compression
• edited 0002 specification file to make it make more sense

• added V1.1.3, moves limiter on PIL image size to maximum limits of LCIF ((2^64-1)x(2^64-1))
• added first draft of LCIF-0003 file format specification
• improved layout of changelog

• added V1.1.1 0002 encoder and V1.1.2 0002 encoder