Control system for The Butterfly Effect. This project uses Arduino Nano with nRF24L01 module.

This used to use Raspberry Pi 3 for the configuration of the lamp and drum locations. However, since the Raspberry Pi 3 broke inside the drum due to rain or some impact, We transferred all the functionality to the code in Drums/MasterDrum.

• FastLED
• DigitalIO
• TimerOne
• LowPower
• SPI
• EEPROM
• RF24

As there was a mistake in how the PCB (printed circuit board) was designed, we also need to change the RF24_config.h file.

1. Uncomment the line #define SOFTSPI
2. Find the lines defining the following variables and define them as follows:

#define SOFT_SPI_MOSI_PIN 10
#define SOFT_SPI_MISO_PIN 11
#define SOFT_SPI_SCK_PIN 12

If the PCB design is rectified, ignore this library edits section.