LEDLightBoxAlnitak - PC controlled lightbox implmented using the Alnitak (Flip-Flat/Flat-Man) command set found here: https://www.optecinc.com/astronomy/catalog/alnitak/resources/Alnitak_GenericCommandsR4.pdf
- Created By: Jared Wellman - [email protected] here https://github.com/jwellman80/ArduinoLightbox
- Adapted to V4 protocol, motor handling added By: Igor von Nyssen - [email protected]
Last modified: 2020-01-19
Typical usage on the command prompt below. Please note that commands end in CR '\r' and responses end in LF '\n'. Neither end in both, so do not use Serial.println. The character in OOO is the letter O, not the digit 0.
Send : ">SOOO\r" //request state
Recieve : "*S19OOO\n" //returned state
Send : ">B128\r" //set brightness 128
Recieve : "*B19128\n" //confirming brightness set to 128
Send : ">JOOO\r" //get brightness
Recieve : "*B19128\n" //brightness value of 128 (assuming as set from above)
Send : ">LOOO\r" //turn light on (uses set brightness value)
Recieve : "*L19OOO\n" //confirms light turned on
Send : ">DOOO\r" //turn light off (brightness value does not change, just the state of the light)
Recieve : "*D19OOO\n" //confirms light turned off
Tested with this stepper motor: https://smile.amazon.com/gp/product/B01CP18J4A and these boards
- Arduino Uno - https://smile.amazon.com/gp/product/B01EWOE0UU
- Arduino Leonardo - https://smile.amazon.com/gp/product/B00R237VGO
and NINA imaging software: https://nighttime-imaging.eu
React
Typescript
Django
Laravel
Facebook
Microsoft
Google
Alibaba
D3
Tencent