saibotflow / marax-monitor Goto Github PK

Hi,

Thank you for your great work. Works like a charm… using it without reed sensor. 👍

I have an lelit pl62x v2 with latest software. So the modes changed by lelit.

If I put the xmode switch in 0 position, the machine works in coffee mode. So the heater is not on during brewing. The display showing a little X above the timer.

In xmode switch 1 the machine is in steam priority mode. Heater is on during brewing. it shows a little c on the display.

can so make it print a c for coffee mode and a s for steam mode?

And what would be nice if the timer starts in brewing I would like to have the timer full screen.

Regards
Jan

Hi @SaibotFlow , huge thanks for providing the code! I alrady bought the reed sensor option when i saw your post. Makes things much more cleaner and easier.

However with the Arduino Nano the previous 3D file from alexrus does not fit as he used a NodeMCU board which is alot bigger than the nano. If i use the 3D casing file he provided then it wont fit.

I understand you are only responsible for the coding side but in any chance you are knowledgeable in the field of 3D printing and can kindly provide a file for a casing that will fit the Nano?

Hi, this is my error at Arduino 2.2.1

Hi!

Do you have any idea where the GND pin is located on the marax?
I'd like to connect that to the Arduino in order to be sure that the connection is stable...

Hello Saibot,

I have tried to change your code to make it work with a Pro Micro controller and a 1602 display. But as I have no real coding knowledge I think I failed a bit. As far as I can tell I got the Display to show all the data I want, but actually no values from the MaraX. Maybe you can have a look at the code on my page and eventually help me out. However you decide... Thanks :)

Greetings Croosi