Actuators ID connect to controller openCR and Interface U2D2 about robotis-op3 HOT 4 CLOSED

Hi,

1. communication map
   It's not exactly same with Robotis-OP3, but I think you can understand how to connect between the actuators after looking the below image.
   

2. U2D2 power hub
   You don't need to use U2D2 power hub. OpenCR acts like that. you have to download a firmware for using in Robotis-OP3.(link)

from robotis-op3.

Hello,

thank you so much for your help. To your screenshot, it must be this: JST_4P_EXT_5Port_Board.
Where can I order the three following items: JST_4P_EXT_5Port_Board, OP3_GPIO_Board and OP3_LED-AMP_Board?

Thanks so much for your patience!

from robotis-op3.

Hi,

I'm sorry but we don't sell them separately.
I think you have to make your own boards using the schematic.

Regard,
Kayman

from robotis-op3.

This issue will be closed since there were no actions for a while. You can reopen this issue to show this issue to the users whenever. Thanks.

from robotis-op3.