ploopyco / nano-trackball Goto Github PK

What were the changes at ede7c89 ?
I just printed an old version. Is there any major fix?
Thank you!

From instructions in the wiki:

make ploopyco/trackball_nano/rev1_001:via

returns the error

make: *** No rule to make target 'ploopyco/trackball_nano/rev1_001:via'. Stop.
|
|  QMK's make format recently changed to use folder locations and colons:
|     make project_folder:keymap[:target]
|  Examples:
|     make dz60:default
|     make planck/rev6:default:flash
|

Looks like the directory 'keyboards/ploopyco/trackball_nano' is not actually in the repo

Assuming the firmware is pre-flashed into the chip. I expected it works after I plugin the USB cable to my Mac. But I can see the white LED is light but the cursor won't move. Is there extra step I was missing?

Hello
I would like to purchase it.

Cannot be shipped to Japan.
Can't you buy it?

https://www.ploopy.co/nano-trackball

Readme on main page of this project says that firmware is released as GPLv3. QMK is released as GPLv2.

MOS.U.2-6 is directly connected to 3 full copper layers, which makes it an insanely good heat sponge when soldering.

I mean, a lot of ground is great, but 3 layers? That's not ground, that's a heat sink. 🤣

From what I can tell, the via firmware can't be built from the https://github.com/ploopyco/nano-qmk-firmware/tree/pinkyball repo. Seems like there isn't a via keymap folder in the Nanos directory.