Giter Club home page Giter Club logo

android_device_samsung_golden's People

Contributors

andi34 avatar andrzejressel avatar benzonat0r avatar m-chojnacki avatar maclaw avatar pedromcostaandrade avatar percy-g2 avatar

Stargazers

 avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar

Watchers

 avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar  avatar

android_device_samsung_golden's Issues

SIM-PIN gets asked, but no radio available afterwards (i8190N)

On a i8190N, when booting, I'm asked for the SIM-PIN. But there is no radio available afterwards.

When dialling *#*#info#*#* and going to the Phone-Infos, the radio is "Unknown" and I can not select any radio.

I tried many tips I found in the internet, like rebooting several times in combinations with switching flight-mode on and off, re-inserting the SIM card, taking the battery out for a few minutes, etc.

I also tried different basebands (all of them working with stock firmware) without success.

This happens with cm12.1_golden.nova.20150627.zip and AFAIR with these, too:

  • cm12.0_golden.nova.20150428.zip
  • cm11.0_golden.nova.20150311.zip
  • cm11.0_golden.nova.20150131.zip
  • cm10.2_golden.nova.20141021.zip

Anything I can do to help debugging this?

Note: This may be related with #50: i8190N identifies itself as plain i8190.

Few contacts in "All Contacts" in SMS/Connections

After some update I don't see all my contacts from SIM card (just few of them) if you write new SMS on a list that shows after "All contacts" in options in both cases. I had all contacts on those lists at CM11 on S3 mini just not long ago

Compass does not work properly

This applies to KitKat 4.4.4 (CyanogenMod 11.0) 20140910. Full wipe install using NovaFusion’s TWRP Recovery v2.8.0.0 20140911.

In many applications the compass does not work at all or only in a defective way:

  • "Swiss Army Knife" does not even shot a compass tool, since it assumes there is no compass sensor.
  • OSMAnd does also not show the compass direction.
  • GPS Status & Toolbox sometimes shows the compass direction. But most of the time it only points straight north, as it thinks there is no compass at all. Some times it just wanders around and does not stand still.

The only place, where the compass seems to work is the compass tile in the notification drawer (but even there it sometimes just stays straight north).

In Stock ROM all applications work fine - so there seems to be a problem with the compass.

[cm12.1_golden.nova.20150525] Bugs

I cant post comments in the blog so I will post here

Bug report:
1-Torch doesnt fix yet. After three or four times the cell restarted by it self.
2-Turning on bluetooth and hotspot at same times make the phone very lagging/unresponsive

System notifications failure

I'm not sure if is the correct place, but I had downloaded CM from here and found 2 issues: http://forum.xda-developers.com/showthread.php?t=2521593

  1. A problem with automatic bright: doesn't work from bright control panel
    and
  2. An issue with "Relax mode" (or similar - I don't know how it says in English). When I set this mode from status bar icon, then the device turn his sounds completely off and I don't know how no enable again. I tried by the same button and keeping pressed and check and uncheck the box but nothing.

if is the correct place, I could split this issue in 2 :)

thanks in advance

RIL issues.

Hello

I have big problems with RIL.

=3G data bug=
I always lose 3G data so often and i always have to turn on/off airplane mode 10-15 times per day and reboot my phone 3 times per day. This must be fixed quickly. It's very annoying when it lost data 50 times per day.

=Airplane mode bug=
Sometimes the Airplane mode takes 10-15 to activate airplane mode. When i turn off airplane mode, RIL take 10-15 sec to connect to mobile mast.

Hangs for 10 secs, when en/disabling wifi hot spot

Hi,
first of all, thank you for the great work!
After testing several versions of the golden rom, i'm still having issues when enabling, or disabling the wifi hotspot. My device freezes for approximately 10 seconds when turning wifi hotspot on, or off. That duration is a little bit longer, when connected to a bluetooth headset. This is not amusing, when listening to music, as the player then hangs, too and needs to bee restarted. :) After reading through the bug tracker, i couldn't find a report for this. Please let me know, if there is a workaround, or an existing solution. If not, what information do you need to reproduce? (last tested on cm 11-20140713-UNOFFICIAL-golden + before)

Thank you, cheers,
McCurly

Can't disable 'Home unlock'

Settings -> Lock screen -> Button Actions -> Home unlock (Pressing the home button unlocks the device)
If option is unchecked device should be unlock only by power button, but it's not working.

[CM11] Auto-Brightness not working on S3 mini I8190

Hey,

I hope I'm right here since I can't find something called "bugtracker" on the novafusion page and there are no links to it.

Well, I'm using a Samsung Galaxy S3 mini I8190 with CM11 and the auto-brightness function is not working. When I press the "Auto" button, the settings button on the right appears and immediately disappears again. So the auto-brightness is completely out of work.

Thanks a lot for any help!

P.s.: The twilight app is not working as well -- I think this is related to this issue. The preview works fine but the deamon doesn't change any color.

Phone turns off when full charged

hi, maybe is an issue or battery problem but everytime i charge (full) the phone i find it powered off.
i've changed my battery last monts and have done full reset before installing the last rom.

Device encryption not working

Device encryption does not work with CM11 on Galaxy S3 Mini. Battery is charged > 80%, PIN/Password is set. After starting device encryption a green android appears, but nothing else happens. Hitting the "back" button leads back to to settings menu.

messaging app can't send/receive MMS

s3 mini CM 12.1 release (20150711)

bug: unable to receive/send MMS (mobile data internet and sms works perfect)

tried deleting and manually creating APN’s didn't workt…

solution: installed an other messaging app (SMSSecure (open source, available on F-droid) and now i am able to send and receive MMS perfectly

hi! could you please help me?

I use your device tree to build AOSP-ROM and stolknuls a problem vser works fine except for this function the, sometimes the image flikering, advise how to fix it.
sori for my english

Better Documentation

Are there possibilities to document the construction process, so I can help with the project?.
I do not know how to begin to compile this rom.

Thanks and Regards
Fabricio

Cannot set notification sound for e-mail / no notification on arrival

In the E-Mail app (not gmail) go to setting and then select an account.
In the account's settings try to set a notification sound. You can select anything from the list, but when the list closes, the notification sound is set to "none".
When an e-mail arrives, no notification sound is played.

Version: 11-20140623
Build: cm_golden_userdebug 4.4.4 KTU84P 2f8b33bd2c
Device: GT-I8190 XXANF3

Indicator for network mode (2G/3G) in notification tile defective

This applies to KitKat 4.4.4 (CyanogenMod 11.0) 20140910. Full wipe install using NovaFusion’s TWRP Recovery v2.8.0.0 20140911.

When I reboot the device or turn it back on after it was powered off, the network mode tile in the notification drawer shows the last state (in my case "2G" since I only use 2G most of the time to save battery power).

But: The system itself always switches to "3G" after reboot/power up.

Expected behaviour: Either the tile in the notification drawer should also show "3G" when 3G is active after reboot OR (better) the network mode should stay in the selected mode after reboot.

Akku bug!

Phone discharges to ~30% and reboots, after reboot battery status is at 1-10%
or it ends in a boot loop.

Offline charging issue

hi, I have found an issue (which is kind of popular if you check the comments) regarding offline charging. My s3 mini does not seem to be able to charge while turned off, the usual offline battery animation does not show, instead it hangs at the loading animation. I hope this issue can be identified and fixed soon.

Clock issue - Again

Hello,

I looked for clock issues in the change log provided on the maclaw.pl page.
I noticed that it should be fixed since a particular release but since the

"cm11.0_golden.nova.20140921.zip" release it happens much more often than ever
before(for me) that nearly each clock you see on the phone show a different time ;-)

That makes the phone unuseable for alarm-clock purposes in my case.

If there are more information needed i will provide them as fast and good as i can.

Cannot set a ringtone for SMS

In basic SMS application I go to settings, click sound, choose any build-in sound and click OK. The sound is not applied and there is no sound when SMS comes. Same with vibration

MTP over USB not working on I8190

In CM12 (Build 12-2015311-UNOFFICIAL-golden) MTP is not working properly. When I connect the phone to my PC (tried Ubuntu 14.04 and Windows 7) the device will not show any data partitions. Adb is also not working fully, so this may be also USB related:

$ adb devices 
* daemon not running. starting it now on port 5037 *
* daemon started successfully *
List of devices attached 
xxxxxxxxxxxxxx  offline

Additionally, when I open Settings -> Storage -> USB Connection and click on PTP or MTP the settings dialog crashes.

Weird bug on CM Perfomance menu

When I enter the perfomance menu, and do something (like scrolling down the notification bar), the processor min speed sets itself at 1000Mhz and when i return to the menu, it sets back to 200mhz. Using some CPU tuner apps i see that when i leave that menu, it happens to be set on 1000Mhz.
image
image

Local manifest to build from sources

Hi,

I am trying to build this golden rom from sources, can you please share the local manifest with the related aosp projects do remove and the projects to add?

Thanks!

Reboot instead of power off

Hi,
thank you very much for your work!
I hope i'm writing on the correct section. I installed Cyanogenmod 11 on my S3 Mini.
It works fine! Congratulations!

Anyway, i found out a little issue:
if i connect the phone (turned on) to the battery charger and then i turn it off, the phone doesn't power off, but reboots.
So, i have to disconnect the battery charger cable, power off, and then reconnect the battery charger.

Let me know if someone have experienced something like that.

Thanks

Music app does not work

The music application keeps on crashing on opening and does not work at all. Sometimes, it keeps on popping up the not responding dialogue which is very annoying. I had to disable the Music app to get rid of it. I am living without music since the installation of the rom. Please look into this.

Provide the source code for cops

I am trying to solve the same issue in the same conditions and the same symptoms as guys have here and here and here. I can track it's presence since cyanogen 10 and I am still experiencing it on the latest 12 and 11 with Galaxy S3 Mini.

According to the contents of /data/cops.log, I first thought that something goes wrong right from the start (cops_wakelock.c:54 cops_do_wakelock_release(): write() errno=22 (Invalid argument)). So the first thing on my mind was inserting more debug logs into copsdaemon.

copsdaemon can be found inside the "prebuilt" directory, without the source code. I found the leaked source of NovaThor on GitHub. I managed to compile copsd, insert the logs and run it.

Unfortunately, that error seems pretty normal. It writes "cops" to /sys/power/wake_unlock to reset the lock in case it had been activated before the daemon launched. If the lock was not active, it gets "Invalid argument" and it seems OK. Hovewer, inserting cops_wakelock_acquire() before cops_do_wakelock_release() does not eliminate this error. Further debugging is impossible since my copsd was configured in "emul" mode, and looks like it must be configured in "modem" mode for the real world. This involves much device-specific configuration and is hard without prior knowledge of the internals.

So finally my question is, do you have the configured source code of cops or did you just copied it from the original Samsung firmware? If you have it, could you provide it?

No FM Radio Support

Hey in the CM12.1 Rom does not working the FM radio. I use the app Spirit1: Real FM Radio. It working with cm11.

Upload videos

I'm not able to upload videos to instagram with the ROM

Recommend Projects

  • React photo React

    A declarative, efficient, and flexible JavaScript library for building user interfaces.

  • Vue.js photo Vue.js

    🖖 Vue.js is a progressive, incrementally-adoptable JavaScript framework for building UI on the web.

  • Typescript photo Typescript

    TypeScript is a superset of JavaScript that compiles to clean JavaScript output.

  • TensorFlow photo TensorFlow

    An Open Source Machine Learning Framework for Everyone

  • Django photo Django

    The Web framework for perfectionists with deadlines.

  • D3 photo D3

    Bring data to life with SVG, Canvas and HTML. 📊📈🎉

Recommend Topics

  • javascript

    JavaScript (JS) is a lightweight interpreted programming language with first-class functions.

  • web

    Some thing interesting about web. New door for the world.

  • server

    A server is a program made to process requests and deliver data to clients.

  • Machine learning

    Machine learning is a way of modeling and interpreting data that allows a piece of software to respond intelligently.

  • Game

    Some thing interesting about game, make everyone happy.

Recommend Org

  • Facebook photo Facebook

    We are working to build community through open source technology. NB: members must have two-factor auth.

  • Microsoft photo Microsoft

    Open source projects and samples from Microsoft.

  • Google photo Google

    Google ❤️ Open Source for everyone.

  • D3 photo D3

    Data-Driven Documents codes.