Also, maybe rename "Diff" to "Fast"? Might not be clear to end users that Diff is Fast.

http://nefariousmotorsports.com/forum/index.php?topic=981.0title=

It is Win7 specific, fresh install, clicking the button will not open the open file dialog box. It just hangs

Clicking on Verify Checksums will crash the program. Tested both on WinXP and Win10 (fresh installs)

Complete bootmode support or remove the option entirely from the UI, which shouldn't show it at all if it isn't supported yet.

http://wixtoolset.org/documentation/manual/v3/howtos/redistributables_and_install_checks/check_for_dotnet.html

i set baud rate to 38400, still connects at 10400. Any ideas?

Same version forces user to uninstall then run the installer again.

This should be done in one pass.

Somebody with more experience than me in wix should fix this.

On occasion when i diff write, the car wont start and i get a code for ECU programming not completed in VCDS. I diff write the file again and problem solved. Using 29F800BB layout and RossTech Hex-Can USB cable.

ECU identified with following data:

HWNumber    = 0261207997       (requested was 0261207997)
SWNumber    = 1037504192       (requested was 1037504192)
PartNumber  = 8E0910560G       (requested was 8E0910560G)

I started with jumping to 4.8 but the end result is aiming for .NET 7 (laetst released) whcih also will make this work in Linux/Mac/Windows.

GUIs suck.

Note: there is no way to integrate a -rc or -nightly workflow because MS doesn't support chars in versions.

Since we no longer need FTDI ID support for licensing, it should be relatively easy to get generic COM port support working.

Default baud rate when you first launch nef is screwy

Changing baudrates sometimes requires restarting the program.

Windows 7 64bit. First time bug reporting using Git, so apologies if I didn't follow the correct protocol, or give enough details...

"Disconnecting because no response was received for the Tester Present message.
Disconnected"