This 3D printed case houses a Raspberry PiZero and .96" OLED screen.
The design was done in Fusion 360 and stays close to the original dimensions of a standard cassette tape. Neodymium magnets are used to snap the case shut.
The PiZero is currently running a headless install of Raspbian. I would like to revise the case to include some type of momentary switches along with a breakout for some of the GPIO pins.
When SSHing into the device, a python script is launched to emulate the boot sequence of an old terminal.
- Raspberry PiZero
- .96' OLED Screen
- Piezo Speaker
- Add wiring diagram
- Clean up case design
- Create Requirements.txt
- Upload .STLs