kikobeats / farm-core Goto Github PK

🚨 You need to enable Continuous Integration on all branches of this repository. 🚨

To enable Greenkeeper, you need to make sure that a commit status is reported on all branches. This is required by Greenkeeper because it uses your CI build statuses to figure out when to notify you about breaking changes.

Since we didn’t receive a CI status on the greenkeeper/initial branch, it’s possible that you don’t have CI set up yet. We recommend using Travis CI, but Greenkeeper will work with every other CI service as well.

If you have already set up a CI for this repository, you might need to check how it’s configured. Make sure it is set to run on all new branches. If you don’t want it to run on absolutely every branch, you can whitelist branches starting with greenkeeper/.

Once you have installed and configured CI on this repository correctly, you’ll need to re-trigger Greenkeeper’s initial pull request. To do this, please delete the greenkeeper/initial branch in this repository, and then remove and re-add this repository to the Greenkeeper integration’s white list on Github. You'll find this list on your repo or organization’s settings page, under Installed GitHub Apps.

Version 0.1.5 of errno was just published.

This version is covered by your current version range and after updating it in your project the build failed.

errno is a direct dependency of this project, and it is very likely causing it to break. If other packages depend on yours, this update is probably also breaking those in turn.

Your Greenkeeper Bot 🌴

🚨 You need to enable Continuous Integration on all branches of this repository. 🚨

To enable Greenkeeper, you need to make sure that a commit status is reported on all branches. This is required by Greenkeeper because we are using your CI build statuses to figure out when to notify you about breaking changes.

Since we did not receive a CI status on the greenkeeper/initial branch, we assume that you still need to configure it.

If you have already set up a CI for this repository, you might need to check your configuration. Make sure it will run on all new branches. If you don’t want it to run on every branch, you can whitelist branches starting with greenkeeper/.

We recommend using Travis CI, but Greenkeeper will work with every other CI service as well.

Once you have installed CI on this repository, you’ll need to re-trigger Greenkeeper’s initial Pull Request. To do this, please delete the greenkeeper/initial branch in this repository, and then remove and re-add this repository to the Greenkeeper integration’s white list on Github. You'll find this list on your repo or organiszation’s settings page, under Installed GitHub Apps.