https://s3.amazonaws.com/kazutan-autoconfig/ospf-lab.jpg
-
01_ospf-lab-set-interface.rb
-
Configure Interface
-
02_ospf-lab-set-ospf.rb
-
Enable OSPF on each interface : use network command, max path 32
- Check OSPF LAB image for loopback ospf configuration
- Configure MD5 Authentication(key:cisco) between R1-R2 R1-R3 R1-R4 R1-R5
- area 1 is summarized as 192.168.0.0/16
- area 0 is summarized as 192.161.0.0/16
-
03_ospf-redis-connected.rb
-
Redistribute R7's loopback address to OSPF
-
External Route is summarized as 192.167.0.0/16
-
04_ospf-tshift-R3.rb
-
Traffic shift on R3
-
05_ospf-demand-circuit-and-flood-reduction.rb
-
Configure demand circuit on R7
-
Configure flood reduction on R6
-
07_ospf-basic-default-route.rb
-
Generate default route injection into OSPF on R1
-
Delete tthis configuration
-
08_ospf-advanced-default-route.rb
-
TBD
-
09_ospf-change-area1-to-stub.rb
-
Configure Area 1 as Stub Area
-
Configure Area 1 as Totally Stub Area
-
10_ospf-change-area2-to-nssa.rb
-
Configure Area 2 as NSSA
-
Configure Area 2 as Totally NSSA
-
01_bgp-lab-set-interface.rb
-
Configure Interface
-
02_bgp-lab-set-eBGP-iBGP.rb
-
Configure simple eBGP iBGP(not using loopback for BGP connection)
-
04_bgp-lab-set-route_reflector.rb
-
COnfigure Router Reflectror
-
05_bgp-lab-set-peer-group.rb
-
Configure peer group on R1 for R2,R3,R4
-
06_bgp-lab-set-weight.rb
-
Change R4 weight as 200 on R1 - simple way
-
Remove this configuration once it's confirmed
-
set weight as 200 only for 192.102.1.0/24 on R1
-
Remove this configuration once it's confirmed
-
07_bgp-lab-set-LP.rb
-
Set local preference as 200 to R3 on R5 - use route-map
-
08_bgp-lab-set-AS-prepend.rb
-
R7: add AS200 201 202 203 to R2, only for 100.0.0.0/24