View Code? Open in Web Editor
NEW
This project forked from koptserg/motion
DIY Zigbee CC2530 Motion sensor (AM312/ AM412/ BS312/ BS412), Temperature /Humidity /Pressure sensor (BME280), Ambient Light sensor (BH1750), Magnet sensor, Light Dependent resistor (LDR)
JavaScript 17.80%
Python 0.61%
C 76.38%
PowerShell 2.57%
Batchfile 2.65%
motion's Introduction
If device in FN(factory new) state:
- Press and hold button (1) for 2-3 seconds, until device start flashing led
- Wait, in case of successfull join, device will flash led 5 times
- If join failed, device will flash led 3 times
- Hold button (1) for 10 seconds, this will reset device to FN(factory new) status
- Go to step 1 for FN device
- Gerber, BOM, Scheme CR2
- Attention! Do not use CR2032 and CR2450 with a motion sensor (AM312 / BS312), as at low battery voltage (<3v) false alarms occur.
motion's People
Contributors
Watchers