jnicolson / esphome-twc-controller Goto Github PK

Should be energy (kwh) and total class.

This can be observed by it not working in HA's energy panel

I don't know if this is an issue or a feature.

When i'm pausing/stopping the charging from the car, the available charge current is reduced to 6 A.
The “Set Current” are not changed but remain as set before. When I then start to charge again, the available charge current remains at 6 A, and the “State” remain at state 8. If I change the “Set Current” to a new value, this new value will be available to the car. And the “State” changes to state 1 and starts to charge as normal.
I have also tested to disconnect the charger cable form the car, when the TWC only offer 6A and are stuck in state 8. When I reconnect the charger cable, the car gets the available current set by “Set Current” and starts to charge as normal.

I have two chargers connected in slave mode, but only one of them is showing up in home assistant. Assuming this project support multiple chargers like the original, how would I go about adding the second one?