107-arduino-mcp2515's Introduction

💾 `107-Arduino-MCP2515`

Arduino library for controlling the MCP2515 in order to receive/transmit CAN frames. This library is prepared to interface easily with libcanard for using Cyphal on Arduino via 107-Arduino-Cyphal.

This library works for

ArduinoCore-samd: Arduino Zero, MKR 1000, MKR WiFi 1010, Nano 33 IoT, MKR GSM 1400, MKR NB 1500, MKR WAN 1300/1310 ✔️
ArduinoCore-mbed: Portenta H7, Nano 33 BLE, Nano RP2040 Connect, Edge Control ✔️
arduino-esp32: ESP32 Dev Module, ESP32 Wrover Module, ... ✔️
arduino-pico: Raspberry Pi Pico, Adafruit Feather RP2040, ... ✔️

Example

#include <SPI.h>
#include <107-Arduino-MCP2515.h>
/* ... */
static int const MKRCAN_MCP2515_CS_PIN  = 3;
static int const MKRCAN_MCP2515_INT_PIN = 7;
/* ... */
void onReceiveBufferFull(uint32_t const timestamp_us, uint32_t const id, uint8_t const * data, uint8_t const len)
{
  Serial.println(id, HEX);
}
void onTransmitBufferEmpty(ArduinoMCP2515 * this_ptr)
{
  /* You can use this callback to refill the transmit buffer via this_ptr->transmit(...) */
}
/* ... */
ArduinoMCP2515 mcp2515([](){ digitalWrite(MKRCAN_MCP2515_CS_PIN, LOW); },
                       [](){ digitalWrite(MKRCAN_MCP2515_CS_PIN, HIGH); },
                       [](uint8_t const d) -> uint8_t { return SPI.transfer(d); },
                       micros,
                       onReceiveBufferFull,
                       onTransmitBufferEmpty);
/* ... */
void setup()
{
  Serial.begin(9600);
  while(!Serial) { }

  SPI.begin();
  pinMode(MKRCAN_MCP2515_CS_PIN, OUTPUT);
  digitalWrite(MKRCAN_MCP2515_CS_PIN, HIGH);

  pinMode(MKRCAN_MCP2515_INT_PIN, INPUT_PULLUP);
  attachInterrupt(digitalPinToInterrupt(MKRCAN_MCP2515_INT_PIN), [](){ mcp2515.onExternalEventHandler(); }, FALLING);

  mcp2515.begin();
  mcp2515.setBitRate(CanBitRate::BR_250kBPS_16MHZ); // CAN bitrate and clock speed of MCP2515
  mcp2515.setNormalMode();
}

void loop()
{
  uint8_t const data[8] = {0xDE, 0xAD, 0xBE, 0xEF, 0xDE, 0xAD, 0xBE, 0xEF};
  mcp2515.transmit(1 /* id */, data, 8 /* len */);
  delay(100);
}

Recommend Projects