3 binaries after install instead of one about bugwarrior HOT 4 OPEN

This seems to contradict the documentation

I have a feeling this is another case of #1007. I'm guessing you're looking at the Command Line Interface page of the "latest" documentation but are installing the "stable" 1.8.0 release.

For context, the top-level bugwarrior command with subcommands has not yet been released. As of right now the top-level command is added as a fourth binary. The original three binaries are still shipped but are no longer documented. I was originally planning to ship the next release with all 4 binaries but now that it's determined the next release will be a major release it's probably best to go ahead and drop them.

from bugwarrior.

You are absolutely correct @ryneeverett However if I set "stable" on the documentation it gives a 404 :)

No worries, I'll continue using the 3 commands for now.

from bugwarrior.

However if I set "stable" on the documentation it gives a 404 :)

Yes, I ran into that myself and it is most annoying. I believe it only happens when you're on a page that didn't exist in the "stable" documentation.

from bugwarrior.

However if I set "stable" on the documentation it gives a 404 :)

Yes, I ran into that myself and it is most annoying. I believe it only happens when you're on a page that didn't exist in the "stable" documentation.

Got it, perhaps a banner on top of the dev docs would suffice in the meantime, with a link to the relevant docs :)

WARNING: you are navigating the dev docs, but you probably installed 1.8 go here to see the docs for your version.

from bugwarrior.