| Supported Targets | ESP32-S2 |
|---|
此例子需要先把tinyusb文件夹替换esp-idf/components/tinyusb下 *注意S2的USB端点fifo只有5个，0、1、2、3、4，所以将0x85分给cdc才能正常收发 #define EPNUM_MSC 0x01 #define EPNUM_VENDOR 0x03
uint8_t const desc_configuration[] = {
// interface count, string index, total length, attribute, power in mA
TUD_CONFIG_DESCRIPTOR(1, ITF_NUM_TOTAL, 0, TUSB_DESC_TOTAL_LEN, TUSB_DESC_CONFIG_ATT_REMOTE_WAKEUP, 100),
# if CFG_TUD_CDC
// Interface number, string index, EP notification address and size, EP data address (out, in) and size.
TUD_CDC_DESCRIPTOR(ITF_NUM_CDC, 4, 0x85, 8, 0x04, 0x84, TUD_OPT_HIGH_SPEED ? 512 : 64),
# endif
# if CFG_TUD_MSC
// Interface number, string index, EP Out & EP In address, EP size
TUD_MSC_DESCRIPTOR(ITF_NUM_MSC, 5, EPNUM_MSC, 0x80 | EPNUM_MSC, TUD_OPT_HIGH_SPEED ? 512 : 64), // highspeed 512
# endif
# if CFG_TUD_HID
// Interface number, string index, protocol, report descriptor len, EP In address, size & polling interval
TUD_HID_DESCRIPTOR(ITF_NUM_HID, 6, HID_PROTOCOL_NONE, sizeof(desc_hid_report), 0x82, 64, 1),
# endif
# if CFG_TUD_VENDOR
// Interface number, string index, protocol, report descriptor len, EP In address, size & polling interval
TUD_VENDOR_DESCRIPTOR(ITF_NUM_VENDOR, 7, EPNUM_VENDOR, 0x80|EPNUM_VENDOR, TUD_OPT_HIGH_SPEED ? 512 : 64),
# endif
};
As a USB stack, a TinyUSB component is used.
- Any board with the ESP32-S2 chip
If you want to set up the desctiptor using Menuconfig UI:
-
Execute in the terminal from the example's directory:
idf.py menuconfig -
Folow to
Component config -> TinyUSB -> Descriptor configurationfor all available configurations.
Build the project and flash it to the board, then run monitor tool to view serial output:
(Replace PORT with the name of the serial port to use.)
(To exit the serial monitor, type Ctrl-].)
See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.
After the flashing you should see the output:
I (328) example: USB initialization
I (327) TUSB:descriptors_control: Setting of a descriptor:
.bDeviceClass = 239
.bDeviceSubClass = 2,
.bDeviceProtocol = 1,
.bMaxPacketSize0 = 64,
.idVendor = 0x00000483,
.idProduct = 0x00000011,
.bcdDevice = 0x00000210,
.iManufacturer = 0x01,
.iProduct = 0x02,
.iSerialNumber = 0x03,
.bNumConfigurations = 0x01
I (357) example: USB initialization DONE
I (367) example: USB task started
Now open new terminal (ie putty). This will let to communicate with esp32 S2 over native USB.
React
Typescript
Django
Laravel
Facebook
Microsoft
Google
Alibaba
D3
Tencent