fenio / homelab Goto Github PK

There is an error with this repository's Renovate configuration that needs to be fixed. As a precaution, Renovate will stop PRs until it is resolved.

Error type: Cannot find preset's package (github>fenio/renovate-config)

This issue lists Renovate updates and detected dependencies. Read the Dependency Dashboard docs to learn more.

This repository currently has no open or pending branches.

Detected dependencies

• Check this box to trigger a request for Renovate to run again on this repository

This issue lists Renovate updates and detected dependencies. Read the Dependency Dashboard docs to learn more.

This repository currently has no open or pending branches.

Detected dependencies

This issue lists Renovate updates and detected dependencies. Read the Dependency Dashboard docs to learn more.

This repository currently has no open or pending branches.

Detected dependencies

• Check this box to trigger a request for Renovate to run again on this repository

In the flux-cluster-template there's a helm chart for cilium that is installed with ansible. How did you install cilium for k0s?

I was also wondering if it's possible to switch to only cilium and remove metallb like was recently done in the flux-cluster-template. Would this work in k0s?

I'm also working on a HA setup using node-local load balancing rather than kube-vip like I would have in k3s. I have 3 controllers and keepalived running on each controller to give a single controller k8s API IP like kube-vip would have provided. Have you tried the same?