PCB design issues during fabrication about uca_board HOT 1 OPEN

Hi Prakash,

This main issues are due to the fact that I've done manually the layout.

So I havent't any schematic document (just the electrical connection shown in the main page of my github.

1. via.drl are PTH, hole.drl are non-PTH

2. I tried to add a maximum of pads for various connection, so some drill distance do not respect the 0.15mm. If it can help, all the drill that do not respect the D2D distance are electrically connected.

3. I confirm that the best option is a suggested, to making short where PAD TO TRACK error found. I used an isolation of 0.25mm between the track that need to be disconnected.

Hope it help

Fabien

from uca_board.