A collection of notes and scripts for passing through GPU to a VM. This is done mostly with Windows in mind.

Mostly just following Arch Wiki on the topic, with a bash wrapper here and there.

With scripts available here it's possible to:

• create the VM from XML config parametrized with scripts/values.sh and vm_config.yaml
• detect changes between the "live" VM and XML config
• apply the above if desired, so the XML config overrides the "live" VM (git is the single source of truth)
• perform automatic pre/post tasks for the vm:
  • start the virtual network
  • isolate the GPU / load the drivers back after VM shutdown
  • isolate the CPUs from host
  • run custom user scripts

Go through the steps listed in Host configuration

First after cloning you'll want to modify the values in scripts/values.sh. This is required, as all the hardware setups are different. What's configurable there:

• GPU IDs required for passthrough
• GPU drivers for loading them back after the VM is shut down
• how much memory the VM gets
• VM name
• audio passthrough options (input and output devices, latency)
• input mouse and keyboard (correct device IDs must be provided)
• physical disks pass-through (limited, at the moment it's hardcoded to two drives)

Notable things that you CAN NOT set through the values file and require manual intervention (editing XML directly) are at the moment:

• CPU pinning (that's one of the most important things to do, don't overlook it)

Then run scripts/setup to create a VM.

Then run scripts/start to actually start it. On the VM shutdown the script will automatically perform the cleanup and finish execution.

The xmls directory contains common configurations.

Common requirements for these are:

• ISOs/virtio-win.iso obtainable via scripts/setup
• ISOs/windows.iso that you have to obtain yourself, the recommended way is to download directly from Microsoft. The version used for testing was Win11_22H2_English_x64v2.iso, but it should work fine with other releases too

These are present in the scripts directory and rely on scripts/values.sh content to be properly filled. Look at the file contents for further instructions.

• iommu_groups (copied over from Arch Wiki) for listing IOMMU groups
• setup for getting the required ISOs and setting up the VM
• start for automation of the binding, isolating, VM startup, etc.
• isolate_gpu small scriptlet for binding GPU to vfio-pci driver
• unisolate_gpu small scriptlet for binding GPU to its defined driver

The configuration is AMD Ryzen 3600 + RTX 4070, thus the instructions for IOMMU will be AMD specific (you may need more parameters for Intel, check the Wiki).

• iommu=pt, to prevent Linux from touching device that can't be passed through

options vfio-pci ids=10de:2786,10de:22bcs

MODULES=(vfio_pci vfio vfio_iommu_type1)

sudo mkinitcpio -P

The list may be inconclusive, as the packages from virtualization group from arch_ansible are also installed.

• qemu-desktop
• libvirt
• edk2-ovmf
• virt-manager

• modify user line in /etc/libvirt/qemu.conf so it points to your USER
• restart libvirtd service

These must be installed from virtio ISO (obtainable with setup.sh to perform the installation.

Storage drivers viostor and vioscsi must be loaded at the early stage of the installation.

Network driver netkvm must be installed later on, when Windows tries to connect to network. At this stage you can press Shift + F10 to get the cmd, which will allow you to press win + e and open the mounted ISO as CD drive. Then run the installer as usual. Alternatively press Shift + x to open the device manager and work from there.