dekay / davisrfm69 Goto Github PK

will this work with the RFM69HCW

I located the missing RFM69registers.h file but there were still 4 #defines missing and giving "not declared" errors:
RF_FDEVMSB_4800 (But RF_FDEVMSB_5000 is in the RFM69registers.h file.)
RF_FDEVLSB_4800 (RF__FDEVLSB_5000_ is there too.)
RF_AFCLOWBETA_OFF
REG_TESTAFC
I couldn't find them defined anywhere in any of the libraries mentioned in the readme or blog. Not sure how to fix this. :-(

Hi,
I think about adding an async receive feature. Since receiving is already interrupt-driven, it should not be that hard - onle the channel swtching code needs to be done in a timer interrupt. I'll test it on my STM32 module, maybe also on ESP8266. But I don't know if it can be done on Arduino as well (I don't have those boards here).
Regards,
Michael.

i have this running on a esp8266 and it shows data do you have a way to decode
so it would show temp wind speed wind direction and all the sensors?

I was just wondering if you were still active on github and if you could email me. I have a Davis ISS from the original Vantage Pro but the ISS board has died. I still have a perfectly good working console but I would like to use an arduino to collect the data and send it back to the console. Is there any way that you can help me figure out the transmission protocol for the original VP1 so that I could code an arduino to communicate with the console. I have been reading all your work and I can see that youn used an arduino to make your own console. I would just like to go the other way around and use an arduino to get my ISS back up and running again. THank you!

I'm trying to compile VP2.ino example with the Arduino IDE v1.05. In the file DavisRFM69.cpp, function DavisRFM69::initialize(), I'm getting compile errors on all the constants, like RF_OPMODE_SEQUENCER_ON. The error is "was not declared in this scope". Any idea how to resolve this?

@dekay
I have an ISS with markings Revision E3, and a Vantage Pro 2.
I built out a 3.3V atmega328P with a RFM69HCW wired appropriately.
have you tested with any of the latest firmware versions or do you know if the RF protocol has changed? Im unable to grab any packets from the ISS and it's sitting right beside the device. The radio initializes correctly and im able to load custom sketches with the RFM69 library and send and receive data.

Please.... Could we have the Hardware hookup image for VP2 example?

Thank's a lot

Hi dekay, thank you a lot for this library.
Do you think that i can replace the moteino for an arduino(with atmega328)+rfrm69?