This is a simple example to show how to use SwiftGPIO by @uraimo on a Raspberry Pi 2. The purpose is very simple: switch on/off or blink 3 LEDs connected to the board with two different GPIO.

Raspberry connections

Board with 3 LEDs and 2 resistances of 300ohm

cd BasicGPIO
swift build
sudo .build/debug/BasicGPIO VALUE

VALUE:

enum Command: Int {
    case one
    case two
    case blink
}

Thanks to @uraimo, @iachievedit and @ubidefeo for the help to setup properly Swift, SwiftGPIO and the board 😃.

• Swift 3.0 on Raspberry Pi 2 and 3
• SwiftGPIO
• SwiftGPIO examples
• Trubles with RPi, Ubuntu and eth0? 👉solution