danorder / flsun-super-racer-full-klipper-config- Goto Github PK

Hello,
pb my Z remains very high despite CALIBRATE and bedtilt, why?
An idea,
thanks

Line 146
sensor_type: Generic 3950 #NTC 100K beta 3950 #reently fixed in latest klipper beta 3950 is dead. don't try to use a older version since the temp table is wrong by 15c.

I had to use NTC 100K beta 3950, was this correct, fluidd couldn't recognize Generic 3950.

I am using the Nano v3

Hi,

Is saw you have a config file for the phaetus rapido.

Could you make a one for the rapido plus HF.

Thank you in advance

extruder section has duplicate settings:

[extruder]
step_pin: PD6
dir_pin: !PD3
enable_pin: !PB3
microsteps: 32
gear_ratio: 50:17 # CHANGE THIS TO WHAT APPLIES TO CUSTOM EXTRUDER THIS IS FOR BONDTECH / BMG CLONE
rotation_distance: 24.963 #DEFAULT VALUE GET THIS FROM THE BONDTECH HOB GEAR. MEASURE THE HOB ON THE LEVER THAT VALUE x 3.14 = ROTATION DISTANCE. FLOW IN SLICER SHOULD BE WITHIN 10 PERCENT UP OR DOWN. FILAMENT TOLERANCE AND DENSITY WILL AFFECT FLOW ACTUAL FLOW.
full_steps_per_rotation: 200 #CHANGE ME TO 400 FOR 0.9 DEGREE Steppers ROTATION DISTANCE WILL AUTOMATICALLY BE CALIBRATED THIS APPLYS TO STEPPING AS WELL NO CHANGES REQUIRED.
nozzle_diameter: 0.400
filament_diameter: 1.750
heater_pin: PE5
sensor_type: Generic 3950 #NTC 100K beta 3950 #reently fixed in latest klipper beta 3950 is dead. don't try to use a older version since the temp table is wrong by 15c.
sensor_pin: PC1
min_temp: 0
max_temp: 300
pressure_advance: 0
pressure_advance_smooth_time: 0.0400
max_extrude_only_distance: 800.0
#control: pid
#pid_Kp: 15.17 # enable these and delete save at the bottom remember to run pid after setup. run fans 25-50 percent before running the command.
#pid_Ki: 1.02
#pid_Kd: 56.27
min_temp: 0
max_temp: 300 #this value is set high for the purpose of hot tightening the hotend. stock hotends / tubes will degrade rappidly past 245. burning ptfe is also a neurotoxin.
pressure_advance: 0 #set this from the slicer / fluidd / Mainsail. or start gcode its easier to do this in slicers with material specic gcode functions. 0.1-1.5 layer hight isn't usally benificial.
pressure_advance_smooth_time: 0.040
max_extrude_only_distance: 800.0
instantaneous_corner_velocity: 2.5 # The equivalent of extruder jerk. this does not speed up pressue advance like linear adance
step_pulse_duration:0