creality3dprinting / cr10-v2 Goto Github PK

Recommend adding lines to the pins_RAMPS.h to swap Z_MIN and Z_MAX pins to allow more simply activating BLTouch by uncommenting two lines in Configuration.h (#define Z_PROBE_USES_Z_MIN_PIN and #define BLTOUCH)

#ifdef BLTOUCH
  #ifndef Z_MIN_PIN
    #define Z_MIN_PIN                         19
    #define Z_MAX_PIN                         18
  #endif
#endif

Edit: Corrected my sloppy code.

Can we get the STEP or DWG files for the parts that are different from the original CR-10?
I'm specifically looking for the X carriage plate that holds the hotend.

I need the pinout for the bed connector and the hotend. Can anyone find these?

All documentation is missing.

No Firmware
No Source
No Config files
not even a user guide.

Please provide all of these.

I'm trying to rig up a basic servo/microswitch Z probe on a CR-10 V3, which I believe is the same hardware as the V2 except with an E3D Titan as standard.

This printer has a daughterboard with a dedicated BLTouch connection.
I want to know which pin this interface operates on so I can rig up a servo and microswitch in its place.

There's no pinout documentation as far as I can tell. @sexycyborg as others have said here, please prod Creality for more documentation and source code on this repo, the community will thank you for it!

Creality CR10 V3
Board: Creality 2.5.2
Firmware: Marlin

I need the schematics, pins maps and PCB layout to this board. I can't find it in anywheare.