I tried to simulate the models with the induction machines (OpenModelica, 1.16.2) and had some problems to get a solution. The compiling process works fine but afterwards the calculation progress first shows 1% and then immediately jups back to 0% and never changes again. I stopped the calculation after a few minutes.
I tried several models out of the other packages and all worked well. Also the models 'IMC_Steinmetz', 'IMC_Inverter1' and 'IMC_Inverter2' had no problems.
My name is Masood and I am currently trying to study the fault detection of HVDC systems. So I decided to look at a simple cases like disconnection of a load part (through break off a cable) and then isolation of the part by help an isolator and circuit breakers.
This example is brought up in an article (Figure 9) : https://www.sciencedirect.com/science/article/abs/pii/S0378779610002166
I am interested in modeling the the scenario of Figure 9 in that paper. That can help me a lot in understanding and modeling the scenarios in OpenModelica.
However as I am new to the simulation with OpenModelica I would like to ask you to help with that example.
This is very vital for my study.
I really appreciate if you could get back to me ASAP.