Arduino programming using Tinkercard simulator
GND
- * Ground Port
5V
- * Volt Port
Black - Ground Wire
- * Ground Wire
- It takes energy from the circuit
Red - Energy Wire
- * Volt Wire
- It gives energy to the circuit
Protoboard
- Device with multiple serial ports
- Connections are shared in series with other port pins
Resistor
Arduino
- Arduino Board
- Amper: 40mA
Led
- Led lamp device
- The "+" is for power, and the "-" is for ground, the bigger wire is the "+" and the smaller is the "-"
- Amper: 15mA
Setting up a Motor
- 1. Connect the red wire on 5v port
- The red wire is for volts
- 2. Connect the black wire on GND port
- The black one is for grounding
Setting up a Motor with Protoboard
- 1. Connect the red wire on the protoboard
- The red wire is for volts
- 2. Connect the black wire on a diferent protoboard port (vertical)
- The black one is for grounding
- 3. Connect the 5v volt port from arduino on a vertical pin where is placed the motor red wire
- They share the same vertical ports so they need to be in the same vertical line
- 4. Connect the Ground volt port from arduino on a vertical pin where is placed the motor Black wire
- They share the same vertical ports so they need to be in the same vertical line
React
Typescript
Django
Laravel
Facebook
Microsoft
Google
Alibaba
D3
Tencent