anycubic-3d / anycubic_kossel_source_code Goto Github PK

Hi,
With this firmware we are unable to retrieve config (after reboot or with M501)
The problem is around a logic with AUTO_BED_LEVELING_BILINEAR in configuration_store.cpp, trying to read data which hasn't been saved.

I made some changes and it works... do you accept pull request?

Saludos,
abc

When I start printing, the printer's temperature is reached to settings below.

Settings
Nozzle : 240 degree Celsius
Bed : 105 degree Celsius

The temperature is over the numbers of settings, but not start printing.
I have to toggle the nozzle setting about -5 to 5 degree.
How do I change setting to start the temperature is reached to a target.

        // TODO: Store the filename checksum to verify if a none-long filename aware system modified the file table.

undefined

Hi,
Controller fan on port 7 stay on all the time, it won't turn off when the temp is below 50.

I found this code in Marlin_Main.cpp
in void loop() {

pinMode(CONTROLLERFAN_PIN,OUTPUT); digitalWrite(CONTROLLERFAN_PIN,HIGH);

even if I commit this lines, the auto fan will not work at all

this is configuration_adv code

#define USE_CONTROLLER_FAN

#if ENABLED(USE_CONTROLLER_FAN)

  #define CONTROLLERFAN_PIN 7 //Pin used for the fan to cool controller (-1 to disable)

  #define CONTROLLERFAN_SECS 60 //How many seconds, after all, motors were disabled, the fan should run

  #define CONTROLLERFAN_SPEED 255  // == full speed

#endif

Any help

You can take a precompiled firmware of the last bugfix version of marlin (2.1.x) on the link below:

https://www.printables.com/fr/model/274342-anycubic-kossel-linear-plus-firmware-marlin-211-bu