blackmagic-espidf is a project which aims to support debugging SWD and JTAG targets over wifi by integrating blackmagic probe firmware to the espressif IDF platform for esp8266 and esp32.

• All the debug features and supported targets of the blackmagic firmware
• GDB server on TCP port 2022 and UDP port 2023
• Serial port server on TCP port 23 and UDP port 2323
• Serial port over websocket on embedded http server (powered by xterm.js) @ http://192.168.4.1
• OTA updates over tftp
• Platform debug messages terminal over http://192.168.4.1/debug.html

esp8266 module with >= 2MB flash. Default configuration is set for 4MB flash for OTA updates. It's possible to configure for other flash sizes. see make menuconfig

By disabling OTA it should work on 1MB devices.

Connecting to serial terminal can be done using socat:

socat tcp:192.168.4.1:23,crlf -,echo=0,raw,crlf

Download all *.bin files from folder firmware and flash via esptool.py with command:

esptool.py --chip esp8266 --baud 115200 --before default_reset --after hard_reset write_flash -z --flash_mode dout --flash_freq 80m --flash_size 4MB 0xd000 ota_data_initial.bin 0x0000 bootloader.bin 0x10000 blackmagic.bin 0x8000 partitions_two_ota.bin

Grab the toolchain from https://github.com/espressif/ESP8266_RTOS_SDK#developing-with-the-esp8266_rtos_sdk and add it to $PATH.

git clone --recursive https://github.com/walmis/blackmagic-espidf.git
cd blackmagic-espidf
make menuconfig # optional, if you want to change some settings
make
make flash # this will flash using esptool.py over serial connection

You may also need to install ZLIB using MINGW32, and the command pacman -S zlib-devel.

To use the ESP8266 in Station mode, in the Blackmagic configuration section:

• Configure Station mode
• Specify the SSID and password you wish to connect to. NOTE: The SSID is case sensitive
• (optional) Specify a hostname to make it easier to connect to the probe.

When working on blackmagic-espidf it is frequently desirable to continue to use the ESP8266 UART for debugging. To achieve this you can disable Monitor target UART in the Blackmagic configuration section.

In this mode you will be unable to use the ESP UART to monitor the target and connecting the ESP UART to the target may result in undefined behavior since the debug messages will be sent to the target.

If the firmware is already on the esp8266 device, it is possible to flash using tftp. Make sure you have tftp-hpa package installed then run:

make tftpflash

Instruction and download at Visualmicro