Application send "$10=1" when disconnecting from bluetooth about grblcontroller HOT 5 CLOSED

Application requires buffer report to work properly.
It sends $10=2 during startup if not already configured in firmware.

On disconnect it will try to restore the original value. As some other applications don't like $10=2
$10 only supports 0 or 1 or 2
Not sure why it needs 511 to work properly.

from grblcontroller.

FYI
#114

from grblcontroller.

Application requires buffer report to work properly. It sends $10=2 during startup if not already configured in firmware.

On disconnect it will try to restore the original value. As some other applications don't like $10=2 $10 only supports 0 or 1 or 2 Not sure why it needs 511 to work properly.

He @zeevy
Thanks for your reply.
$10=1 and $10=2 make very poor info in the status messages.
In grblHAL there're lots of options available in $10 parameter:

If I set $10=1 or $10=2, I will not get info about speed, spindel, position coordinates etc. That's why I need a higher debug level in grblHAL firmware.
And it looks strange for me that the application tries to modify GRBL settings implicitely. Can we somehow avoid this?

from grblcontroller.

Unfortunately it can't be avoided for now, as the application is build with grbl 1.1 compatibility.
I will try to change the behavior in upcoming releases

from grblcontroller.

I'm closing the issue in this case, thanks @zeevy

from grblcontroller.