Can't use IP tunneling communicate about node-red-contrib-knx-ultimate HOT 6 CLOSED

Hello, happy new year.
What make/model of IP router are you using?

from node-red-contrib-knx-ultimate.

KANONTEC KTS1

from node-red-contrib-knx-ultimate.

Hello
If your device is this
http://kanontec.com/files/datasheet/KTS1.pdf
As far as i can tell, it’s an IP Router, it cannot act as a tunnel device. It can maybe act as ETS programming device, but i think it's only a router.
If it works as ip interface, maybe it has only 1 tunnel, that is occupied by ETS.

from node-red-contrib-knx-ultimate.

Yeh, It's a programming device, very useful, Can implement a lot of logic.

Found the reason, it should be a Tunneling client is not enough. I have used knxd to add a few additional clients and are ready to use them.

Thank you for your help

from node-red-contrib-knx-ultimate.

Hi @Supergiovane ,

I have a problem. Can you help me?

Problem Description

1. Unable to program KNX device

I can't download the device (partial download, full download, download application) through the serial download tool and KNX IP gateway. It can be downloaded at first, but the device shows no response (T_Disconect) when the download is halfway through.

2. KNX messages sent through the KNX panel and network, sometimes it takes many times for the device to respond.

Case: When I send a KNX message through APP (or use ETS software), the device is not executed (but the message can be seen in the "group monitoring software"), it will be executed many times before it is executed. It's like the message is blocked.

I think both problems have the same cause

Best Regards
songzh

from node-red-contrib-knx-ultimate.

Hello Songzh

You need to proceed by steps.
First, i'll replace the ethernet cable
Second, i'll try to connect the PC running ETS and the KANONTEC KTS1, together to a separate switch.
Third, do you have another KNX/IP Router around to test with? If yes, i'll test with a different KNX/IP Router.

Then you can try to reboot the KANONTEC each time you program a device. If, after each reboot, ETS can program the device, that means that the KANONTEC does have some problem.

from node-red-contrib-knx-ultimate.