Applying filters. about lsm6dsox HOT 2 CLOSED

Hello @alvaro-oliver ,
as you can see in the datasheet of the component (section 6.4.2), a LPF2 is already active in the digital chain of the sensor. So, the output data are already filtered. If you want, you can activate also a HPF and a LPF1, but we did not export explicit APIs to do it. Anyway, you can use "Read_Reg" and "Write_Reg" APIs to configure the registers of the component and so you can use them also to configure the HPF and LPF1 filters, following the instructions in the datasheet.
Best Regards,
Carlo

from lsm6dsox.

Thanks Carlo, I'm going to give it a try and comment back. I'm trying to get 416 Hz gyroscope data LP filtered at 24.6 Hz.
Regards,
Álvaro

from lsm6dsox.