DFU Serial Instructions about nrf52832_breakout HOT 3 CLOSED

I've cleaned up the Makefile, and added a bit more to the bootloader README, which documents how to build the bootloader.

To burn the bootloader onto an nRF52832, you'll need a hardware programmer. I'd recommend grabbing an nRF52832 Development Kit, which can serve as a development platform for the nRF52 as well as a programmer for external chips.

Software tools like nRFgo Studio or Nordic's command-line tools can be used to load code onto the chip.

from nrf52832_breakout.

Hi Jimblom. I got the NRF52 DK and the Jlink EDU programmer. I was able to sucessfully program the sparkfun NRF52832 breakout board using Keil (J-link EDU). However, now I can't seem to go back and program through arduino. When I try to burn the bootloader using NRFgo studio and the bootloader hex file "sfe_nrf52832_dfu.hex" found in the repository it fails and gives an output saying:

Im not sure how to go around this. Thanks.

from nrf52832_breakout.

@boppana113 I am also stuck with this same thing for long time.. Did u find a solutions for this.. ?

from nrf52832_breakout.