Two EdgeBars in one addin about solidedge.community.addin HOT 8 OPEN

Got it working. I just released an alpha NuGet package for you to test with. Give it a shot and let me know. https://www.nuget.org/packages/SolidEdge.Community.AddIn/109.0.0-alpha1

from solidedge.community.addin.

I emailed a SE developer for clarification. I'm still not 100% certain that I understand what he said but I will be testing this functionality this week.

from solidedge.community.addin.

Thank you very much, I am looking forward for the result.

from solidedge.community.addin.

I got feedback from development. I have tested their suggestions but I am yet to get it to work with 2 EdgeBar pages. A lot of people are asking for this so I won't forget about it or stop trying. I'll followup when I know more.

from solidedge.community.addin.

Thank you, I appreciate it.

from solidedge.community.addin.

Hi,
thanks for the update. I have tested it. It works fine if I open one document (then both edge bars are visible.). But I think there is still an issue if more documents are open one by one. And the behavior is different for parts and assemblies. Here are my results:
first asm doc - ok, both edge bars are visible
second asm doc - ok, both edge bars are visible
third asm doc - no edge bar
fourth asm doc - no edge bar

first part doc - ok, both edge bars are visible
second part doc - ok, both edge bars are visible
third part doc - only the second edge bar is visible
fourth part doc - ok, both edge bars are visible

Could you check this? Thank you.

from solidedge.community.addin.

Hi guys,
any progress on this issue?

from solidedge.community.addin.

@jlnewell, hi, I also encountered with similar problem. I tested the alpha ver and managed to get both edgebars in the demo addin (couldn't be done before).
The problem I had is that when I try to replace the edgebar page in a specific doc (by removing all prev pages and inserting the new one), I can see the new bar only after manually resizing the panel.

from solidedge.community.addin.