[tracking] Bugs found by the peripheral selftest about riot HOT 4 OPEN

@maribu I could provide configuration for SPI in nucleo-f070rb using ONLY datasheet - I do not have access to this board.

from riot.

Hmmm ... I'm looking at pinout of nucleo-l152 - and Arduino D11, D12, D13 are connected to PA7, 6 and 5. This is configured in periph_conf.h and is compatible with datasheet (page 40). What I'm missing?

from riot.

Hmmm ... I'm looking at pinout of nucleo-l152 - and Arduino D11, D12, D13 are connected to PA7, 6 and 5. This is configured in periph_conf.h and is compatible with datasheet (page 40). What I'm missing?

Indeed, that looks all fine.

I guess I confused it with nucleo-l433rc which indeed has configured the incorrect bus. I'll update the tracking accordingly.

from riot.

So that I have this handy later on, I paste the crucial part of the test output on the nucleo-f446re here:

Starting test for GPIO-IRQ (both-edges) at tests/periph/selftest_shield/main.c:588
FAILURE in tests/periph/selftest_shield/main.c:596
FAILURE in tests/periph/selftest_shield/main.c:601
FAILURE in tests/periph/selftest_shield/main.c:606
FAILURE in tests/periph/selftest_shield/main.c:611
FAILURE in tests/periph/selftest_shield/main.c:616
FAILURE in tests/periph/selftest_shield/main.c:628
FAILURE in tests/periph/selftest_shield/main.c:632
FAILURE in tests/periph/selftest_shield/main.c:637
FAILURE in tests/periph/selftest_shield/main.c:642
[FAILED]

Note: This failure is sporadic.

from riot.