Failed to call service vacuum/start. 502 : send command. about hass-gardena-smart-system HOT 11 OPEN

OK. This stuff never ceases to amaze me.

After just pressing play in Home Assistant today to get my Mower going and mowing, it, contrary to all expectations, left the garage and started. Funny thing being that I did not change anything on either side of the installation. So not on the side of the Mower and not on the side of HA.

What I did do following the suggestion of @danroeg is write the following to Husqvarna:

Should Husqvarna have been involved in fixing this issue I would like express my thanks and at same time ask to comment either here or reply to the email I sent. So as to establish a two communication with which we could possibly float idea's for the greater community and your costumers.

Aham.

from hass-gardena-smart-system.

@Aham330 thanks for the update - I’ve tested and indeed I can once again manually start the mower, which is a great relief. Thank you for chasing Husqvarna and good luck with the pets.

from hass-gardena-smart-system.

@Aham330 have you recently done a firmware upgrade? I have 502 bad gateway problems and mower not starting on START_SECONDS_TO_OVERRIDE since the last update

from hass-gardena-smart-system.

Hi @danroeg thanks for you reply.

unless the mower auto updated itself after having switched off the mower I dont think I updated. Nor do I think it did that cause I don’t have auto updates on.

The mower app works fine and starting my vacuum robot works fine too.

from hass-gardena-smart-system.

I'm having similar issues here. The mower works fine in the Gardena app, but home assistant can no longer start it.

If I recall correctly there was an update for the mower a couple of weeks ago, which had to manually be installed in the app and required a reboot.
Even after this update everything was fine, until a couple of days ago.

from hass-gardena-smart-system.

yes sounds familiar. please also write to husqvarna dev team to fix the api

from hass-gardena-smart-system.

from hass-gardena-smart-system.

Hi @grm

Any luck with the reproduction?

greets

Aham

from hass-gardena-smart-system.

Hello, any updates here?

from hass-gardena-smart-system.

This is a problem for me as well. I get the error vacuum/start. 502 : connection lost

from hass-gardena-smart-system.

thanks j3mu5. meanwhile i’ve been experimenting with the serviceId parameter of the native gardena smart api, with or without :cbtg suffix as suggested elsewhere. nevertheless start_seconds_.. no longer works with the sileno

from hass-gardena-smart-system.