High Amperage use about esp_rgbww_controller HOT 2 OPEN

hey @borodamd, I have created a newer version of this board here https://github.com/pljakobs/esp_rgbww_controller/tree/Feature-externalGPIO-pmue.
This isn't optimized for high currents, and I would in general not advise you to plan for high currents. Why? because the strips are usually not designed for such high currents. I'm currently running a strip that is about 9m long at, at full RGBW load, draws about 6.5A, but at that load, you can already see a clear discoloration at the far end.
If you need to provide 20m, I would suggest to break that down into four strips of 5m ea.
There is a refactored firmware available that provides mqtt based synchronization between multiple controllers, see here https://github.com/verybadsoldier/esp_rgbww_firmware/wiki

I think such a setup would give you more reliability and flexibility. Also, I would suggest to consider running 24V strips (six per LED group rather than three) which will half your current requirement and make the whole design a lot more easy. You might then get away with two controllers.

pj

from esp_rgbww_controller.

Thanks for advices. I already use strips 24v, but put separate RGB and CWW strips. But put line to separate controllers and sync them is good point. Also i planning to make firmware at ESPHome. It will be more flexible and sync from it will not be a problem.

Thanks again

from esp_rgbww_controller.