[Issue] Pcap dump / Xiaomi Mi Note 3 / Fail to detect current RAT about qcsuper HOT 2 OPEN

Hello!

Thank you for your interest in QCSuper. QCSuper is normally able to receive both 3G layer 3 packets (delivered with WCDMA_SIGNALLING_MESSAGE) and 3G NAS payloads, which are embedded into layer 3 packets (delivered with LOG_UMTS_NAS_OTA_MESSAGE_LOG_PACKET_C).

It seems that your baseband is communicating NAS payloads in a way that is understood by QCSuper, but that it is not the case with layer 3 packets, or it is delivering these using another log type than WCDMA_SIGNALLING_MESSAGE which may be not parsed yet.

If you wish to help us troubleshooting this, could you please perform a raw capture of the Diag logs sent to the modem (through running ./qcsuper.py --adb --dlf-dump /tmp/your_output_file.dlf), and send the produced .DLF file at mmr at p1sec ｄｏｔ com? Feel free to perform a few actions (e.g switching on/off plane mode, generating data traffic, etc.) and wait a bit while performing the capture. Thank you!

I noted that the same issue may have been reported in #10.

Regards,

from qcsuper.

Hi p1-mmr!
Did this issue get resolved?

I have the same issue that I am not able to capture any traffic with the option --include-ip-traffic.

I have tested on a Samsung Galaxy S5 and Samsung Galaxy Note 4 with the same result.

What type of debug logs can I provide to you so that you are able to investigate the issue?

Thanks!

from qcsuper.