Fails to build about validity90 HOT 10 OPEN

I'm not the developer of this driver, but I believe that the libfprint driver isn't ready for use(or even for compilation). If you want to test, try the prototype.

from validity90.

Oh, that one fails to initialize the device:

validity90.git/prototype # ./prototype | grep "Expected"
Expected at char 012
Expected len: 84, but got 2
Expected len: 76, but got 16
Expected len: 4104, but got 2

validity90.git/prototype # ./prototype | tail -n5
0000 40 01 01 00 00 00 00 00 00 00 10 00 00
usb read:
0000 af 04
Expected len: 4104, but got 2
Invalid rsp6, can't get public key

from validity90.

What reader are you using? Looks like it might not be supported by this project

from validity90.

Bus 001 Device 003: ID 138a:0090 Validity Sensors, Inc.

from validity90.

Please correct me if I'm wrong, but since the driver is not ready yet I don't think you should be able to build that yet. If you go to validity90.git/prototype instead and make, does that work? Because I think that's all that is supposed to work so far. But I might be wrong.

from validity90.

Well, as I say in the 3rd comment: libfprint provided with this repo fails to build; and the prototype does build but fails to initialize the device. Unsure why.

from validity90.

Ah. Do you run the prototype as root (sudo ./prototype)?

from validity90.

Yes. If you read the comment carefully you'll notice the sharp sign.

from validity90.

I saw that, but everyone has a different prompt.

from validity90.

@zippy2 Have you used the device with windows? If not, try to install it in a VM(if you don't want to install it on hardware), setup your fingerprint and try prototype again

from validity90.