A library to support introduction to robotics engineering.

RBE1001Lib Doxygen

• ESP32Servo 0.9.0
• ESP32AnalogRead 0.0.5
• ESP32Encoder 0.3.8
• Esp32WifiManager 0.12.0
• ESPmDNS 1.0
• FS 1.0
• Preferences 1.0
• WebServer 1.0
• WiFi 1.0

The RC controller is hosted by the ESP32 as a website.

The Detailed documentation is here: https://github.com/madhephaestus/Esp32WifiManager

HOWTO enter passwords:

You will use the Serial Monitor to enter the name of the network and the password to use. The ESP32 will store them for later. First type the SSID you want and hit send It will prompt you for a password, type that and hit send

The ESP will default to trying to connect to a network, then fail over to AP mode

To access the RC control interface for Station mode you will watch the serial monitor as the ESP boots, it will print out the IP address. It should look like this:

WiFi connected! DHCP took 8 IP address: 192.168.37.44

Enter that address in your computer or phones web browser. Make sure your ESP and computer or phone are on the same network.

In the lab, you will want to use AP mode. To set the AP, type AP:myNetName to set myNetName as the AP mode and hit send the ESP will prompt you for a password to use, enter it and hit send

To make the ESP use AP mode by default on boot, change the line in RCCTL.ino

manager.setup();

to

 manager.setupAP();

To access the RC Control interface in AP mode, connect to the ESP with either you phone or laptop then open in a browser on that device and go to:

http://192.168.4.1

to access the control website.

NOTE you can use this class in your final project code to visualize the state of your system while running wirelessly.