OVBSC: not entering thermostat mode when strike temperature reached about stc1000p HOT 7 CLOSED

Do you have any additional information on this issue?
Have you checked the APF flags are set correctly?
I don't get a ton of feedback from users, but at least a few have reported OVBSC working as expected.

from stc1000p.

will be brewing again tomorrw and will recheck, I realise it's a kinda vague report :(

from stc1000p.

As far as I can tell, it doesn't switch off the S0 output when St is reached, only when the alarm is acknowledged and you enter the "pause" mode for dough in.

from stc1000p.

That is excellent information! Makes it a lot easier to troubleshoot. I'll look into it. Thanks!

from stc1000p.

Are you running the latest code (that is current from master branch)?
Because, I've been mulling over the piece of code, knowing what to look for, and it really looks like it should switch to thermostat mode with PO output right after St is reached and before the alarm/pause.
Cheers!

from stc1000p.

I'll have to try again, going to have to get on it more anyway, if I ever want to nail down this mash temp

from stc1000p.

After brewing again tonight, I believe this is behaving "as designed" but it's very susceptible to the tuning of the P0 factor :| Setting S0 to a low enough ratio to not overshoot much is just pointlessly slow, so it overshoots there (no circulation to keep the thermoeter stable) and then P0 has a tendendecy to either heat too much or not keep heat. I believe my P0 setting was simply too high in the past.

from stc1000p.