Having issues getting input about access-control HOT 6 OPEN

Update to this; I'm testing it with a wiegand library on my arduino and it is working, so I don't think it's anything electrical/hardware, if anyone has any thoughts they'd be greatly appreciated.

from access-control.

@kothmann1 did you resolved your issue? Looks related to #84

from access-control.

No, it did not work without piface, I ended up writing a custom solution where I used a microcontroller to convert the RFID output to UART and print to the RPi and took leosac out of the loop.

from access-control.

Mhhh ok, for the record do you remember trying https://leosac.github.io/leosac-doc/doc_output/develop/da/d7f/page_module_sysfs_gpio.html? Thanks.

from access-control.

I have updated the documentation on https://leosac.github.io/leosac-doc/doc_output/develop/d8/d25/page_guide_rpi_wiegand.html.

I would recommend to use a Level Shifter for prototyping.

Btw a coming Leosac update will also add support for proper Wiegand format decoding (not your issue but it will facilitate the format decoding of individual fields like Uid, Facility Code, ...).

from access-control.

I did try the sysfs module at the time, and I was using a level shifter from 5V down to 3V3, wiegand output was reaching the pi pins at 3.3V per my oscilloscope. It might be related to the fact that I was using a Rpi4 and an RPi zero W to test instead of the Rpi1 this was built for, but not sure.

from access-control.