Use with 4.2.2 board about ender3v2-klipper-configs HOT 1 CLOSED

I have an Ender 3 V2 running the stock 4.2.2 board, with a CRTouch and Sprite Extruder.

I was able to install these configuration files just now (with a few features disabled such as KAMP...for now) and can confirm it's looking good so far, I don't actually see any obvious differences between the instructions for 4.2.2 and 4.2.7.

Klipper has successfully connected to my printer and it's showing the current temperatures. Next up I need to run some calibrations, then see if I can get a print going.

Edit: I take that back, as soon as I tried to home the bed nothing happened. Turns out the pins on 4.2.2 are different, as per #8
I copied over the step_pin and dir_pin settings from here and that fixed it: https://github.com/Klipper3d/klipper/blob/master/config/printer-creality-ender3-v2-2020.cfg

from ender3v2-klipper-configs.